Mirror the part to create the other 1/2 of the part. Create lines on an angle knowing the starting point and angle. Create parallel lines, by defining the offset direction and distance.
TUTORIAL #3Objectives:The Student will design a 2-dimensional drawing by: Create arcs polar knowing the diameter, location, start and end angles.
Mill Level 1 Training Tutorial ContentsGetting Started. Windows, Windows XP, Windows Vista and Windows NT are registered trademarks of Microsoft Corporation. Microsoft, the Microsoft logo, MS, and MS-DOS are registered trademarks of Microsoft Corporation NSee is a registered trademark of Microcompatibles, Inc. Trademarks Mastercam is a registered trademark of CNC Software, Inc. This document may not, in whole or part, be copied, photographed, reproduced, translated or reduced to any electronic medium or machine readable form without prior consent, in writing, from In-House Solutions Inc. Copyrights This manual is protected under International copyright laws. Some jurisdictions do not allow the exclusion or limitation of implied warranties or liability for incidental or consequential damages, so the above limitation or exclusion may not apply to you. has been advised of the possibility of such damages. be liable for direct, indirect, or consequential damages resulting from any defect in the manual, even if In-House Solutions Inc. Should the manual prove defective following its purchase, the buyer (and not In-House Solutions Inc., its distributer, or its retailer) assumes the entire cost of all necessary servicing, repair, of correction and any incidental or consequential damages. manual is sold or licensed "as is." The entire risk as to its quality and performance is with the buyer. makes no warranties, either express or implied, with respect to this manual or with respect to the software described in this manual, its quality, performance, merchantability, or fitness for any praticular purpose. Disclaimer Of All Warranties And Liability In-House Solutions Inc. reserves the right to make improvements to this manual at any time and without notice. All rights reserved Software: Mastercam X5 Author: Mariana Lendel ISBN: 978-1-92 Revision Date: OctoNotice In-House Solutions Inc. Mastercam X5 Mill Level 1 Training Tutorial Copyright: 1998 -2010 In-House Solutions Inc. To order more books: Call 1-80 or Visit or Contact your Mastercam dealer
0 kommentar(er)
